Brocade Communications Systems 825 Anleitung zur Fehlerbehebung PDF herunterladen (Seite 119)

Brocade Adapters Troubleshooting Guide 95

53-1002145-01

Diagnostics

4. Select Queue Test.

5. Click Start.

SCSI test

Use the fcdiag --scsitest command to test SCSI components and display discovered LUN

information, such as LUN number, device type and qualifier, vendor ID, product ID, revision number,

size of LUN, and LUN status.

fcdiag -–scsitest <port_id> <rpwwn> [-l <lpwwn>]

where:

port_id ID of the port from that you want to test. This could be the PWWN, port

hardware path, or user-specified port name. This could also be the

adapter-index/port-index. For example, to specify adapter 1, port 1 use 1/1

as the port identification.

rpwwn Remote PWWN to which you want to trace the route.

lpwwn Logical PWWN. 0 indicates the base port or else the virtual port.

Trace route

Use the BCU and HCM to trace the SAN path between the adapter and remote end point.

Tracing the route through BCU

Use the fcdiag --traceroute BCU command to trace the route between end points.

fcdiag -–fctraceroute <port_id> <rpwwn> [-l <lpwwn>]

where:

port_id ID of the port from which you want to trace the route. This could be the

PWWN, port hardware path, or user-specified port name. This could also be

the adapter-index/port-index. For example, to specify adapter 1, port 1 use

1/1 as the port identification.

rpwwn Remote PWWN to which you want to trace the route.

lpwwn Logical PWWN. 0 indicates the base port.

Tracing the route through HCM

Use the FC Trace Route test to trace the route between the adapter port and a Fibre Channel target

port. To run this test, use the following steps:

1. Launch the HCM.

2. Select Configure > Diagnostics to display the Diagnostics dialog box.

3. Click the FC Protocol Tests tab.

4. Select FC Trace Route.

5. Select the adapter port and target for which you wish to trace the route.

1 2 ... 114 115 116 117 118 119 120 121 122 123 124 ... 171 172

Keine Kommentare

Brocade Communications Systems 825 Anleitung zur Fehlerbehebung Seite 119